Others

You’ve got a used Millermatic sitting in the shop, or you need to order a replacement part, and nobody can […]

You’re setting up for a project and your machine tops out at 200 amps. Before you strike an arc, it’s

If your AC stick welder produces a smooth arc at some amperage settings but suddenly becomes erratic, stubborn to start,

You just picked up a multiprocess welder that handles MIG, flux-core, stick, and TIG, and now you’re staring at a

You’ve loaded flux-core wire, set the polarity, and now you’re staring at the voltage and wire-speed dials wondering where to

Rust shows up on gate hinges, tool surfaces, trailer frames, and welding fixtures. Sometimes it’s a light surface blush you

Overhead MIG welding is one of the most challenging positions you’ll face in the shop or on a job site.

Sheet metal is one of the trickiest materials to MIG weld. The margin between a clean bead and a burned

Spatter is one of the most common complaints in MIG welding. Those tiny molten balls that fly off the arc

If you own a Miller Big 40 welder-generator and need to track down warranty coverage, order parts, or verify the

Grabbing the wrong drill bit before cutting 1/8 NPT threads is one of the most common shop mistakes. The hole

An independent planning estimator for MIG and Stick welding parameters including recommended amperage, wire feed speed, duty cycle load, shielding gas flow rate, heat input, and electrode burn-off rate based on material thickness and process type.

Choosing between MIG and TIG welding trips up a lot of people — not because the processes are mysterious, but

If you’ve been shopping for welders or browsing metalworking forums, you’ve probably come across the term “IMIG welding” and wondered